Before applying, ensure your lashes are free from makeup and oil; they must be completely clean and dry. We recommend working on one eye at a time.
Patch testing: Conduct a patch test at home or by a professional to ensure you do not have any adverse reactions to our products. Apply a small amount of lash bond to the outer corner of your eyelashes and wait 24 hours to see if a reaction occurs. If a reaction or sensitivity develops, please discontinue use. For patch testing the sealant, please follow the same steps for the other
Brush a thin layer of ‘’Bond ’’ from Aurora Lashes on your natural lashes, paying close attention to the root of your natural lashes. If you are going for a more dramatic and longer lasting hold, we recommend taking the BOND further up the lash for a stronger hold and apply a small amount of Bond to the root of the lash cluster.
Use the applicator tool to gently remove your first lash piece from the tray, starting with the outer corner of your eye, and work across your lash line.
Place the lash piece underneath your natural lashes, slightly away from the waterline, and press the lash cluster against the roots of your natural lashes. Repeat with the remaining pieces, working inwards.
Ensure that no adhesive is on the tweezers as this can cause them to stick to the lash cluster. Clean any glue off the tweezers between applications.
Dab a thin coat of Sealant under the lashes to seal them with your own lashes to eliminate any sticky residue, paying close attention to the base of the lashes.
Do not brush or pull the wand through your lash clusters. The seal will eliminate any sticky residue and cure the adhesive bond. Wait 2-3 minutes and repeat this step if you feel the bond is still sticky/tacky.
After applying the sealant under your lashes, use the applicator or your fingers to press the lash pieces against your natural lashes.
Tip: Apply sealant to the applicator before gently clamping your lashes.
Allow approximately 30 seconds for the sealant to dry. Avoid getting the lashes wet for the next 24 hours to ensure the set is secure, enjoy your new fresh set of lashes!
Removal:
Our Aurora Lash Remover is designed to work seamlessly with our bond and sealant, dissolving the adhesive and safely removing the lash clusters.
Gently brush the remover on the lashes, good to allow the remover to stay on for 1-2 minutes and brush to remove the glue.
Use the Remover wand to take off the lashes and any remaining residue.
Clean any leftover residue with Aurora Lash shampoo.
How to clean your lashes for reuse:
- Place your Lash Clusters on a paper towel or cotton pad.
- Brush them gently with Aurora Lashes remover and wait up to 30 seconds.
- Carefully wipe away any residue with a cotton bud.
- If needed, repeat the steps above, if necessary, until the lashes are clean.
- Store your lashes back in their original tray, ready for reuse.
